i dont have my alldata account since i sold my shop but any toy Lexus question go to lexreme.com awsome people know antthing Toyota/lexus 2 minutes to register to post on forum includes diagrams tip forced induction experts everything i personally use this site for my 90 lexus ls400 i did some homework for you its inder the inke manifolf under throttle body with a single wire coming from it
under the intake manifold
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
It should be on the back side engine. The side which is facing the firewall.
The knock sensor is located on the side of the engine block near the bellhousing
replace it.
It is located on the side of the engine block. If you have a code for a knock sensor and you have a noise in the engine, it will set the code. That does not mean that the sensor is bad. They very rarely give problems.
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
The "knock sensors" for the Avalon 3.0 are facing the firewall on the engine block just below the cylinder head ,their are two knock sensors .
Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.
It is screewed into the side of the engine over by the starter.