0
Where is a oxygen sensor on a 1997 firebird v6 and wheres the cheapest place to buy a decent one?
Wiki User
∙ 18y ago
a 97 should NOT be having problems with the O2 sensors. but there are many. A couple right behind the manifolds and also on the exhaust pipe. But there could be many other reasons the O2 sensor could be showing up as a problem code. Try running some Lucas injector cleaner through a tank of gas before you change what could be a working sensor. david vol-dolfan@msn.com
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is the number 2 oxygen sensor at on a 1999 pontiac firebird v6?
your bank 2 sensor is the o2 sensor on your passenger side exhaust manifold
Where is the o2 sensor bank 2 sensor 1 on a 1999 firebird?
bank 2 is the opposite side of cylinder #1. check the plugwires to see what side #1 cylinder is on and its the other side oxygen sensor
Where is the map sensor located on 86 2.8L firebird?
there is no map sensor on it
Where is crank sensor on 1991 firebird 3.1L?
3.1L dont have a crank sensor
Where is the o2 sensor in a 99 firebird located?
the exhaust, where every o2 sensor is
Where is the IAT sensor in a 1995 V6 3.4lt firebird?
You can find the 1995 Pontiac Firebird 3.4 liter engine IAT sensor on the back of your engine. The IAT sensor will be a few inches above the transmission.
Where is the locations of oxygen sensor for Mitsubishi Outlander?
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Do you need a oxygen sensor for headers?
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
Where exactly is the location of your oxygen sensor heater in a 2002 rodeo?
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
Does a 93 firebird have a mass flow sensor?
If it has fuel injection it has one
Where is the speed sensor located on a 91 firebird?
on the transmission tailshaft housing
Change oxygen sensor on 95 Oldsmobile cutlass ciera?
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
