"bank one" is misleading on a four cylinder engine, since there is only one bank to begin with. Bank 1, sensor 1 is the upstream O2 sensor screwed into the exaust system before the catalytic converter. Bank 1 sensor 2 is screwd into the exaust system downstream of the catalytic converter.
The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.
top rear of engine
where is the number 3 cylinder located on a 2.5 ford ranger engine
I'm not a mechanic / technician but my Chilton repair manual does not show a knock sensor in the engine wiring schematic for the 2.3 liter 4 cylinder in a 1994 Ford Ranger
The variable reluctance sensor is the same as the crankshaft sensor on the 92 Ranger. It is on the front of the engine beside the crankshaft pulley.
Bank 1 = The side of the engine the Number 1 cylinder is on Sensor 1 = between engine and catalitic converter Sensor 2 = After cat...
No , the 2.5 liter - 4 cylinder engine in a 1998 Ford Ranger IS NOT an interference engine
No , the 2.3 liter 4 cylinder engine in a 1997 Ford Ranger is not an interference engine
The 4 cylinder engine is 2.3 liters ( 140 cubic inches ) in a 1994 Ford Ranger
According to my Chilton repair manual engine wiring schematics there is ( 1 ) on the 4 cylinder and ( 2 ) for the V6 engines in a 1994 Ford Ranger
The camshaft position sensor is on top of the engine. It is on top of a shaft in the same place that older rangers had a distributor.
Which engine do you have?