It's located above the break pedal
Brake lights? Check brake light switch for adjustment or replacement
The 2005 Subaru backup light relay switch can be found beneath the drivers side dashboard. The backup relay switch will be above the brake pedal.
Normally this is caused by a defective brake light switch or one that is out of adjustment.
where is brake light switch
Check your brake light switch located above the brake pedal. Check to make sure that the brake pedal rests against the switch. When the brake pedal is depressed than the lights should turn on, but when you let go of it, it should return up and meet with the switch.
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
a switch that is trigered to light up the light when the brake pad is pushed in
The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.
The brake light is controlled by a relay switch. If the relay switch is bad the brake lights will stay on. The brake light switch simply plugs in and out. Unplug the brake light switch until you can replace it.
Above the brake pedal. If your main brake lights dont work but your third center brake light does, then the brake light switch is not the problem. Its is the turn signal switch.
The brake light switch can be found below the dashboard on the drivers side of the passenger compartment. The brake light switch simply plugs in and out.
The brake light switch is behind the brake pedal.