0
shared with brake master cylinder.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
Where is clutch slave cylinder on 85 Jeep Cherokee?
It's on top of the transmission. Follow the tube coming from the master cylinder.
Where is the hydraulic clutch fluid reservoir on an 85 zx?
The clutch master cylinder is on the drivers side under the hood behind the brake booster.
Where is the clutch fluid reservoir on a 85 bronco 2?
The clutch master cylinder is under the hood, drivers side, on the firewall. It is between the brake master cylinder and the drivers side fender. The cylinder is very small in comparison to the brake master cylinder. The reservoir is the small white plastic canister above it.
My clutch is leaking on 85 Ford Ranger. I have noticed fluid on the drivers side near wheel but not under the trans bell housing. Is the leak more likely the master cylinder vice slave?
I don't mean to insult, but are you sure you are looking at the clutch master cylindar and not the brake? There is no way fluid from the clutch could make it to the rear wheel. The slave cylinder is most likely the problem if it drips near the wheel. Replace it with a rebuilt unit not a kit.
Does a 1983 Chevy Blazer have a clutch fluid port?
There is a reservoir for the hydraulic clutch under the hood , driver side just above the brake master cylinder reservoir. The clutch also has a bleeder valve on the driver side of the clutch bell housing. full size K5 blazer in 83 does not have hydraulic clutch. small little s-10 blazer does possibly, in 83 but may not until 85 also., you need to know which blazer you have, little one or big one they are TOTALLY different trucks., there was no hydraulic clutch in the full size trucks until 85, including the K5 blazer
Your 85 fiero will change gears when its off but wont change gears when started why is that?
Chances are that your clutch is not FULLY disengaging the transmission when you are depressing the pedal. The clutch is hydraulic with a master and slave cylinder and a hydraulic hose connecting the two. It is basically the same type of system your brakes use. If you get air in the line due to either cylinder or the hose being faulty, it will feel as though the clutch is working but it is not. This can range from a complete clutch failure or just having the clutch "drag". Any force from on the flywheel at a stop will prevent you from being able to put the car in gear...
On a 85 Nissan pick up the clutch is weak the master and slave cylinder was changed about 2 months ago and worked fine until now how do you fix this?
Check the lines between the cylinders to see if you're losing pressure. If that's not it try pushing the transmission plunger back while the clutch is in and readjust the slave cylinder's prong. If that's not it you either have a bad transmission or one of your new cylinders just died on you.
Where do you add clutch fluid to a 85 Honda prelude and will i have to bleed lines?
85 Lude, old school cable clutch... No hydraulics (fluid)
How to install a clutch in kx85?
I have the clutches in my kx 85 but the clutch rode that goes to the clutch cable keeps Hitting the clutch Case How do I fix it
Will a 1985 cr 125 Honda clutch cover fit 1986 cr125?
No, the 86 has 7 clutch plate and the 85 has 6 so the 85 clutch cover is not deep enough. I had the same issue
Does 85 Honda trx 125 have a clutch?
I Have A 88 trx 125 and it has 2 clutches a centrifugal Clutch and A Regular Clutch
