0
hi, you may find that it dose not have a clutch cylinder, as this model usually has a cable. confirm this by following thru from top of clutch pedal. regards razzel
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Why is the Clutch pedal to floor in my 1990 Honda Prelude?
There is no fluid in the system or master cylinder/slave cylinder failure (hydraulic). Cable streched or broken (if not hydraulic).
Where do you bleed the clutch on a 1989 Honda Prelude?
You will find the bleeder valve on the Slave Cylinder, which is mounted on the front of the transmission, by the radiator. You will find it in the front and center of the engine compartment.
How do you install a slave clutch cylinder for a 1994 Honda civic ex v-tech?
The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.
Where is the slave cylinder located on a 1989 Honda Prelude?
should be on drivers side of the firewall
If i replace slave cylinder will that make my clutch disengage and engage correctly?
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
What if your clutch pedal isn't working until you pushe it more than halfway in and its hard to downshift 1989 Honda prelude 2.0?
answerchange master cylinder and slave properly then bleed the system properly.
Where is the clutch slave cylinder fluid located on a Honda Civic?
The brake fluid for the entire system is added in the master cylinder container. The slave cylinder does not have its own reservoir.
Where is your Clutch bleeder Valve on a Duel carborated 1990 Honda prelude?
Its on the slave cylinder which is on the front of the transmission just left of the front engine mount bracket. It looks just like a brake bleeder screw.
Were is the clutch bleed valve on an 84 Honda magna?
It is on top of the slave cylinder hope this helps
Why does your clutch stick to the floor in a 92 Honda accord?
2 reasons: 1. There is no fluid in your master cylinder due to a leaking master cylinder or slave cylinder or 2. You blew your clutch
Where is the clutch slave cylinder located in a 1994 Honda Accord EX?
under the car ... near the clutch housing .... you cant miss it
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
