0
On most lawn mowers the coil and the fly wheel are located under the recoil housing or engine shroud.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
If Lawn mower left in the rain won't start?
Probably a rusty flywheel and coil contacts. Take cover off and sand them.
How do you find the distance between the coil and the flywheel?
If you are talking about a small engine such as a lawn mower, the air gap between the coil and the flywheel is usually is .015 to .020 of an inch. A piece of cardboard from a cereal box can be used as a gauge if you don't have the proper gauges.
How do you know if your coil is bad on john deere lawn mower?
Lt133 lawn tractor will not fire is coil bad
What is an ignition coil on a lawn mower?
It is a magneto, a little piece under the flywheel cowl with two metal tabs that almost touch the side of the flywheel. Embedded in the flywheel is a magnet that provides a signal to the magneto each time it comes around to fire the spark plug.
Were is location of alternator of lawn mower?
generally the alternator sits under the flywheel
How do you time a lawn mower engine?
On most lawn mowers there is no timing - they have the flywheel set, as long as the shear pin is in place, it will put the magnet by the coil at the proper time to fire. The points are run by the gap (you set the gap on the points) and the pin pushes the points open at the proper to fire. The only setting you have to do is the gap on the flywheel to the coil and the gap on the points.
Where is the coil on a Briggs and stratton engine on a tractor mower?
The coil is under the cowling on top of the motor where the flywheel is.
What is the gap on lawn mower torque coil?
ktungutngutbh sluck
How do you find a tool to set the ignition coil gap on a lawn mower?
you can go to any parts store and buy a feeler gauge for a couple of dollars. use that to set the air gap between the coil and the flywheel. use the oem specs
How much will it cost to replace a bad coil on a lawn mower?
$65 + tax
Coil gap 6.5 lawn boy mn10323?
Air gap between coil module and flywheel should be .010 inches.
How do you replace the fly key on a lawn king 6.0 horsepower mower?
you have to remove the flywheel with a flywheel puller or maybe knocking it off with small hammer blows.
