there may be two. one on the block facing the radiator fan close to the trans, the other under the crank pulley
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
The Crankshaft Position Sensor (CKP) is mounted on the top of the transmission bell housing. Assuming you are talking about the 3.3L V6.
The timing sensor is called a Crankshaft Position Sensor (CKP). It is located at the 10 O'Clock positon on the crankshaft pulley.
To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.
where is the crankshaft angle sensor located on a 1997 cadillac deville.
Where is the camshaft sensor located in 1997 Chevy venture
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
A CKP is the crankshaft position sensor. The engine computer uses that sensor to know the position of the crankshaft for fuel and ignition timing purposes. With out the ckp the engine will not run.
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
Lower left side of crankshaft-looking at engine from front.