On the centre console by your left knee, drivers side
it is under the stering wheel...
Before 1995 = OBDI, 1995 and later = OBDII
multi-port fuel injection
Reading diagnostic codes is easy. The driver plugs the reader/scanner into the diagnostic port of the vehicle, and the scanner/reader will give a code if there is a problem, and tell them the type of problem.
as long as they are of the same body type (coupe, sedan, and hatchback) they will fit
No it is not b16a is the civic si motor there is two type R motors B16b came it 96-2000 civic hatch (EK9) and the b18c5 Found it the Acura integra Type R
Should be. If it is then there should be a diagnostic port on the drivers side of the dash near the bottom of it. It will be a port with lots of pin type holes in it. It might have a cover over it.
From port to port it's about $1500-2000, it depends on type of vehicle(SUV or sedan)
Discusss this with the Honda dealer in your area for the type of driving that you do.
The 2000 Jaguar S-Type OBD 2 port is on lower edge of dash; right of steering column
The first generation of the Honda Civic Type R (EK9) was manufactured from 1997 - 2000 and was a huge success. The second generation of the Honda Civic Type R (EP3) was manufactured from 2001 - 2005. The third generation of the Honda Civic Type R (FN2/FD2) was manufactured between 2007 - 2010. There is a new fourth generation currently in the research & developmental stages that is scheduled for release sometime in 2015.
1.5 non vtec!! actually it is a 1.6 D16Y7 same as a 1996 to 2000