front of the engine above the starter,behind the coil packs (where all you spark plug wires are plugged into) remove all six 5.5 mm bolts from the ignition coils unplug two connectors on the left and one on the right.
If you have a 350 with HEI (electronic ignition), it will be under the distributor cap, under the rotor, bolted with two small bolts to the landing of the distributor.
Hope that helps.
there is no way to answer this question without year, model, and engine size information.
Yes the ignition control module is a part of the distributor or d.i.s system intruduced in the late 70's by some manufactuers.
A Mercedes-Benz 300SE ignition control module can be obtained from most Mercedes-Benz dealerships. The ignition control module, can be purchased at most auto-parts stores.
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Transitors
Yes, absolutely
Have you checked for fuel and spark? Fuel pumps ad burnt ignition rotors are very commen on these vehicles
The ignition control module on a 2000 Blazer with the 4.3 is mounted on the same bracket that the coil is mounted to.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
I've reading alot on this latley, and seem to be having the same problem. I believe it can. I am going to replace my ignition control module tonight and see if my injectors then start working on my K2500 7.4
Where is the ignition control module located in my 1992 Crown Victoria
The ignition control module sit directly below the distributor.
ignition control module is under the distributor cap
Where is ignition control module on a 2001 mercury sable
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
A Mercedes-Benz 300SE ignition control module can be obtained from most Mercedes-Benz dealerships. The ignition control module, can be purchased at most auto-parts stores.
The ignition switch is part of the WCM (wireless control module).The ignition switch is part of the WCM (wireless control module).
inside the distributor. pull the distributor cap off and it's attached to the distributor toward the firewall.