left side back of engine by dist.
i think it is the sensor located on the drivers side of the motor rite next to the middle spark plug.
Check the owner's manual.
knock sensor
Where is the knock sensor located on impala SS
It is screwed into the passenger side of the engine block just in front of the starter.
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
The knock sensor is located on top of the block in a 4.8 2002 engine. The intake will have to be removed to get to the sensor.
The knock sensor is basically a one inch thick washer with a sensor plug on it. it will be attached to the block with a bolt that just runs through the center of it The knock sensor module is located inside the little cover on the VCM.
You have another problem other then the knock sensor if the engine will not start and run. A knock sensor will not cause the engine not to run.
The knock sensors yes there are two are located on either side of the motor (4.3LTR Vortec) below the heads in the center area of the engine block. There are a place for another sensor just above where the knock sensor goes but these are for other sensors. The knock sensors yes there are two are located on either side of the motor (4.3LTR Vortec) below the heads in the center area of the engine block. There are a place for another sensor just above where the knock sensor goes but these are for other sensors.
ESC / Electronic Spark Controll Circuit. and the knock sensor signal.
behind the block under distributer