answersLogoWhite

0


Best Answer
Copy

The switch is located on the passenger side just above and to the rear of the motor mount. The plug has one green wire in it and has a red snap clip that ahs to be snapped to one side before you can squeeze the the locking tab to get the connector off. I did it blind from up top just to see what was going on. Its a real PITA. Make sure when your are getting ready to put it back on that you make sure the inside of it is clean. You will need a 1 1/16" deep socket to r/r the switch. the new one should have a thread sealant already on it. If you can turn a wrench, yiou can handle this. The plug is a little tricky. there's a piece of it that flips open, and then there's a sealing dart in the extra port where the vent goes. Can't miss it, its black plastic and brass with a one wire connector (two if its got the vent wire installed).

User Avatar

Wiki User

โˆ™ 2007-04-05 17:04:32
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is lokated oil pressure switch on 2.7l eng.2001 Dodge Intrepid?
Write your answer...
Submit

Related Questions

How do you Change oil sensor switch 2000 dodge intrepid?

how to change oil pressure switch in 2001 Dodge Intrepid I need to look at a diagram


Is there an inertia switch on a 2001 Dodge Intrepid?

No. A 2001 Intrepid does not have an inertia switch.


Where is the ac low pressure switch on 2002 Dodge Intrepid?

the middle left of the motor towards the bottom


Where is the leak detection pump pressure switch located on 1999 Dodge Intrepid?

The leak detection pump switch on your Dodge Intrepid is located beneath the battery. If you can not locate this on your own, it may be best to have a licensed mechanic take a look at it.


What is Freon capacity 1997 intrepid?

Since a 1997 Intrepid has a high pressure cut off switch, it is OK to put a whole 1 pound can of Freon in it. You will need to do this after charging the system.


How do you reset fuel switch after accident 99 intrepid?

There is no fuel pump inertia switch on a 1999 Dodge Intrepid.


Where is the oil pressure switch located on a 1994 Dodge Intrepid with 3.3 engine?

drivers side under exhast manifold


Where is the oil pressure switch located at for a 1999 Dodge Intrepid 2.7?

Passenger side of the engine block, to the rear of the motor mount.


Why would the ac compressor not get power with a good fuse on a 2003 intrepid?

The low pressure switch could be activated because the system is low on freon.


Does a 1998 dodge intrepid with a 2.7 have a fuel shut off switch or an inertia switch?

No


How do you get to the side mirror switch on a 2002 Dodge Intrepid?

To get to the side mirror switch on a 2002 Dodge Intrepid look on the driver side door. The mirror switch is located just above the window up and down switches.


What does the Error Code P0846 on 2002 Dodge Intrepid mean?

Trouble code P0846 means:Transmission fluid pressure sensor/switch "B" circuit range/performance


Can you jumper or by pass a neutral safety switch on a 2001 intrepid?

NoNo


Where is the inertia switch on a 1994 Intrepid?

Dodge does not use inertia switches.


Where is the reset switch for a 2000 Dodge Intrepid?

No reset buttons on a Dodge.


Where is key cylinder switch on 1994 Dodge Intrepid?

It is on the column on the right.


Where is the multifunction switch located on 2002 Dodge Intrepid?

The turn signal switch is part of the multifunction switch.The turn signal switch is part of the multifunction switch.


Where is the light switch in the door of a 1999 Intrepid?

It is part of the latch, inside the door.


Where is the inertia switch in a 2000 Chrysler intrepid?

Chrysler does not use inertia switches.


Is there a reset button on a 1999 Dodge Intrepid?

No. A 1999 Dodge does not have a reset switch.


Where is the inertia switch on dodge intrepid?

Dodge does not use inertia/reset switches.


Why Dodge Intrepid 99 wont shut off after you turn off the switch and take the key out?

Defective ignition switch.


Trunk light switch on a 1999 Dodge Intrepid?

Trunk light switch is part of the trunk light socket assembly...


How do you replace the multifunction switch on a 1997 intrepid?

Remove the tilt steering lever.Remove the steering column cover.Unplug the wire going to the switch.Now you can remove the bolts that hold the switch to the column.An instructional video of how to remove the multifunction switch on a 1993-1997 Dodge Intrepid has been included below.


Does a oil pressure switch monitor the oil level?

A pressure switch reads pressure not level.