A 1995 Bronco does not have an OBD-II port - OBD-II started on 1996 vehicle. 1995 Brocno would have OBD-I. The connector should be under the hood, on the inside wall of the driver's side fender near the firewall.
under the hood on the drivers side by the hood hinge
The Ford Tempo Air Conditioner service port is located in front of the hood latch. The low pressure service port is closest to the firewall.
Where is ac low pressure service port on a 1990 ford mustang
The smaller port is the low side.
The EVAP Service port is on the firewall on the passenger side, right next to the low side service port for the A/C.
There is no 1988 Ford Explorer. The vehicle went into production in 1990 for the 1991 model year, replacing the two door Bronco II;. As for the Bronco II, there isn't an OBD port.
The low side service port can be found on top of the air conditioner compressor. The low side service port will have a blue top.
No. They used Multi- Port fuel injection starting back in 1985 on the 302. Some MPI's are also sequential, but not on the 1993 Bronco.
The 1991 Ford Mustang does not have an OBDII port, because OBDII was not standardized in the United States until 1996.
The Ford Focus ZX2 was produced from the years 1998 to 2003. The low end service port in a 2003 Ford Focus ZX2 is located behind the front of the right front tire.
The 1996 Ford F-250 OBD 2 port is on lower edge of dash middle on dash before glove compartment