0
x308 (1997 - 2002): two knock sensors, one on each bank, under inlet manifold.
Later aj27 model uses ring type sensors.
The connectors are either side of the thermostat housing at the front of the engine.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you replace crank position sensor Jaguar XJ8?
under vechile near rear of engine going in from engine side toward transmission there is a 2 wire sensor with 1 bolt holding it in.
What does a knock sensor bank 1 sensor 1 do?
It detects spark knock (ping) then sends a signal to the ECM to retard timing.
Where is the 2002 GMC Sierra 2500 HD Knock Sensor 6.0 liter located at?
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
How many knock sensors on a 1997 Cadillac eldorado and where are they located?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
What type of oil use for 1999 Jaguar XJ8?
Use SAE 10w-30 Synthetic oil such as Mobil 1.
What is the firing order of cylinders on a 2000 Jaguar xj8?
1-5-4-2-6-3-7-8
Where is a 1999 Corvette knock sensor?
where is the knock sensor circuit #1 location on a 1999 trans am ls1, I have looked everywhere. thanks
What is diagnostic trouble code po325 for a 1998 Chevy truck?
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Replace the Knock Sensor
Where its locate knock 1 sensor in vortec v8 4.8?
The knock 1 sensor on a Vortec 4.8 is located on the top of the engine. You will have to remove the intake to gain access to replace it.
Need help with trouble code p0325 on a 2004 dodge neon?
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Replace the Knock Sensor
How do you change knock sensor 1 circuit malfunction for 1995 chev sonoma?
The circuit 1 knock sensor would be located on the lower right side of the engine block (passenger side). You will need to drain the coolant from the radiator and be prepared for the passenger side of the block to drain coolant when the knock sensor is removed. After you disconnect the electrical connection to the knock sensor, the knock sensor simply unthreads from the block counterclockwise. Apply a thread sealant to the threads of the new sensor and install, no need to over tighten, this is a tapered pipe thread.
Why do codes P0325 P0330 keep coming back on 1999 Toyota sienna?
Trouble code P0325 means: Knock Sensor 1 Circuit (Bank 1) Trouble code P0330 means: Knock Sensor 2 Circuit (Bank 2) Need to replace Knock sensor
