0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is bank 1 o2 sensor in a 2002 Chrysler Sebring in back of engine?
Yes.
How many O2 sensor in 2002 Chrysler Town and Country?
A 2002 Chrysler Town and Country has two oxygen sensors.
Which o2 sensor is bank 1 on a 1997 chrysler LHS?
Passenger side is bank one on a LHS.
What is the part number for an O2 sensor bank 1 sensor 1 in an 2002 Mitsubishi Galant 4-cylinder?
Mitsubishi Galant, 2002, 4-cyl, O2 sensor, bank 1 sensor 1 (upstream)... PART NUMBER: MR506364
Where is the O2 sensor bank 2 located on a 2002 town and country?
There is no bank two on this van.
2002 Dodge Intrepid o2 sensor bank 1?
Bank 1 is the pass side.
What is Chrysler check engine code P0135?
This is a generic O2 Sensor code, usually used on right bank
Error code p0141 Chrysler town and country?
* P0141 02 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2) The after catalyst O2 sensor has failed.
What oxygen sensor should you get for a malfunction code PO155 for a 2002 Mitsubishi Montero Limited and where is the sensor located for repair?
P0155 = O2 sensor heater circuit malfunction (Bank 2 Sensor 1). All O2 sensors are threaded into the exhaust system at various points. Bank 2 would be the bank of cylinders that does not contain the #1 cylinder. Bank 2 Sensor 1 would be the first O2 sensor leading from bank 2 of the engine.
Is the bank 1 sensor 1 o2 sensor on a 97 Chrysler lhs upstream or down stream?
Bank one is the same side as cylinder number one. Sensor one is upstream or before the catalytic converter.
What is po137 02 sensor circuit low voltage bank 1 sensor 2 on 2002 Venture?
Bank 1 Sensor 2 is the sensor AFTER the catalytic converter. Causes could be,A faulty O2 sensor, Exhaust leak near the sensor, Damaged catalytic converter, Damaged wiring to O2 sensor,
Where is O2 sensor bank 1 located on a 2002 chrysler town and country?
Bank 1 sensor 1 is screwed into the exhaust manifold on the back of the engine. Bank 1 sensor 2 is screwed into the catalytic converter.Bank 1 sensor 1 is screwed into the exhaust manifold on the back of the engine. Bank 1 sensor 2 is screwed into the catalytic converter.
