0
Above the oil filter
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the oil sending unit on a 2003 Sebring sedan 2.7 liter?
I had the same on an '04 Sebring Conv. 2.7L.I found the unit (with a mechanic friend's help) on the backside of the engine. It is right in the center of the engine towards the bottom. Sorry if that's a bit cryptic... If I remember right, you will need deep socket to get the unit out.
Temp gauge not working on 1997 Chrysler sebring?
Check your grounding on your temp sending unit.
Where is the oil sending unit on a 2004 sebring convertable?
Back side of the motor ( firewall side).
Why would the temperature gauge not be moving on a Pontiac Montana?
Try to locate the temperature sending unit on the engine and make sure its not a loose wire to the sending unit,if the wire is in place then the sending unit is shot.
How do you find the oil sending unit on a 2002 chrysler sebring?
It is on the back of the engine, Under the exhaust manifold.
Where is the oil sending unit on a 2001 Chrysler sebring 2.7?
It is under a heat shield on the back of the engine.
Where is the fuel sending unit on a 2003 Chrysler Sebring?
The fuel level sensor is on the fuel pump module in the fuel tank.
Where can you locate the fuel sensor on a 2000 chevymalibu?
You mean the fuel sending unit? Top of the fuel tank.
Where will you locate the oil pressure sending unit on a 1995 Chevrolet Camaro 3.4L V6?
Your oil pressure sending unit should be located above the oil filter, on the housing the oil filter screws up to.
The oil light comes on at idle in a 2004 Sebring with the four cylinder engine where is the oil pressure switch and or the oil pressure sending unit and can it be easily replaced?
The oil pressure sending unit is on the back side of the motor on the left side and its not to hard and not to easy!!
Where do you locate oil pressure sending unit on 454 Chevy motor?
usually at the back of the engine around the distributor
Where is the oil signal sending or pressure switch on a 1997 Chrysler Sebring 2.5L V6?
right above the oil filter there is a wire leading to it. it wont be possible to get to the sending unit without taking the oil filter off.
