I have a 2001 Frontier 2wd and it is located underneath the blower fan and motor. The blower fan and motor can be acessed by removing about four Phillips screws and the two other phlips screws that hold the glove box latch onto the dashboard. After the glove box is removed you will see the blower motor. Remove the 3 screws holding the motor to the housing. Now you will see the resistor bock card. It is held in place by two silver Philips screws. Remove both wiring harnesses that go to the motor and to the resistor block before removing screws. Press the connnector tab in first to remove connector before removing screws. Good Luck!
2000 Nissan frontier wiper
It is in the gas tank.
The blower is located under the the passenger side dash. The resistor should be on the left side of the housing.
Its located on the passengers side under the dash in the blower housing............
It is located underneath the glove box on the passenger side along with the resistor.
I HAVE A 2002 NISSAN FRONTIER 4X4 3.3 L V6 I HAVE KNOW IDEA WERE THE KNOCK SENSOR IS LOCATED The knock sensor on the 3.3l model should be under your intake manifold, which means you will have to remove the upper intake manifold to access it. on 2.4l models, it is located on the side of the engine block.
it is on the left hand side of the block about 1 in. from the firewall,
it is on the left hand side of the block about 1 in. from the firewall,
right next to the blower unit.
Open glove compartment, pull in on two tabs on side of compartment to swing door all the way down. Blower motor resistor is located to the left of the blower motor on the back wall of the enclosure. One T-15 Torx head screw holds it on along with the wiring connector.
the only goofie looking board you will find under there
resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money