0
I had the same problem on my diesel 75, it is mounted on the end of the gearbox. I found it easiest to jack up the nsf corner, remove the wheel, then I had good access to pull off the sensor and replace.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why can't I hear the reverse parking sensor in my range rover?
It maybe faulty, a loose wire or a blown fuse are common faults.
What is the size thread for oil sensor range rover 1994 4.2?
what size thread is the oil switch sensor in a range rover 1994 4.2 v8
Where is the speed sensor on rover 200?
where is the speed sensor on a rover 200
Why do the outside mirrors move downward in reverse on 2008 land rover?
The mirrors move to a second position to help with parking, you can adjust the position they move to.
Where is the reverse switch on rover 214?
For the 214 i removed the whole airfilter box... disconnected the switch..Just incase anyone wondered.. its right below the air filter box.. ontop of the gear boxthe 214 reverse switch is 22mm hex size.
Where is the parking buzzer on a rover 75?
where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working
How do you change the reverse sensor on a rover 216?
R65 Type transmission Disconnect battery. To improve access to switch you could remove the air cleaner. Disconnect the the wiring connector to the switch which is located on the side of the gearbox. Unscrew the switch and remove. Refitting is the reverse of above but a new sealing ring shoukd be fitted. PG 1 Type transmission As above for battery. Jack up car, switch is on top of the gearbox. May need to remove the under shield to get at the switch. trace the wiring back from the switch until you come to a connector and disconnect. Refitting is reverse of above but a new seal should be used.
Rover 200 will not start in neutral just a click but will start if put into reverse gear?
Could it be the Neutral Safety Switch is out of alignment? Thinks Reverse is Neutral? I don't know Rovers, but there is a safety switch in vehicles with Automatic Transmissions, that prohibit the vehicle from being started in a Driver or Reverse gear.
Where is the inertia switch on 1996 range rover?
whereis the inertia switch on a 1996 range rover
How do you replace a crankshaft sensor on a 1997 Landrover Discovery?
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
Where is the fuel switch of a 2004 range rover?
Where is the fuel relay switch in a 2004 range rover located
What sensor does the mars rover have?
something
