behind the timing belt covers
The crank angle sensor is located in the distributor.only in the 94 and 95 Honda accord.
No the ckf and the ckp are not the same sensor for a 2000 Honda civic. The crank fluctuation sensor is behind the crank pulley and can be changed fairly easy with some mechanical knowhow when the timing belt is done. The crank position sensor is built into the distributor. To change this sensor you would have to rebuild the inside of the distributor or replace the entire distributor. Hope this answers your question.
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
In the bottom of the distributor under coil.
Is it a 1.5l or 1.6l?? 1.6l its in the distributor housing. Not totally sure on the 1.5
Avoid the crank sensor?
Where is the crank pulley located on a 1991 honda civic dx
more than likely the mechanic that changed the timing belt didn't put the crank position sensor wire back on the timing cover and the alt belt burned the wires going to the sensor throwing a code. crank senor no signal
Where is the crank position sensor hole on a 2003 Blazer
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
its behind the crank pulley on that gear at the end of the crankshaft on the timing belt side of the motor