It is integrated into the PCM (ECU).
The barometric pressure sensor is located on the left side by the carborater, it has 2 vacume lines and a electric connetion.
Manifold Air Pressure or Barometric Pressure sensor is out of range
fuel pressure sensor is located on the tank
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
The fuel pressure sensor is located on the fuel rail attached to the fuel pressure regulator.
The 2003 Mondeo does not have a IAT Sensor is has a Temperature and Manifold Absolute Pressure Sensor (TMAP) The TMAP sensor fits directly into the inlet manifold and accurately measures the vacuum from the engine. The TMAP sensor consists of a temperature sensor and a pressure transducer and therefore replaces the IAT and the MAP sensors. The TMAP sensor provides the powertrain control module with information relating to inlet manifold vacuum and barometric pressure along with the temperature of the air in the inlet manifold. With the ignition on but without the engine running the sensor reads barometric pressure and when the engine is running, the sensor reads inlet manifold vacuum.
The oil pressure sensor on an f250 engine is located at the back toward the firewall. It is centered side to side close to the intake.
Connected to the master cyclinder.
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
As far as I can tell Ford's have either a map sensor or a maf sensor but not both. I believe 2004's use the maf sensor. MAF means mass air flow, and the sensor is located just past your air filter. It is a large cylindrical piece that air flows through, around 3-4 " in diameter and has an electrical plug on the side. For older vehicles you have a map sensor, which is a barometric pressure sensor usually located on the sidewall of the engine compatment. It is a small plastic piece mounted on the side with one cable going to it.
There is no fuel pressure sensor.
The oil pressure sensor on the 1992 Ford F-150 5.0 is located next to the oil filter attached to the block of the vehicle. It is attached to the oil filter bracket and has wires that send information to the computer.