answersLogoWhite
Car Electronics and Lights
Headlights Tail and Brake Lights
Acura Integra
Jeep Cherokee

Where is the Brake light switch 1999 Jeep?

272829

Top Answer
User Avatar
Wiki User
Answered
2007-05-27 13:25:35
2007-05-27 13:25:35

Look at the upper end of the brake pedal almost under dash

123
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The brake light switch is behind the brake pedal.


The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.


The brake light switch is connected to the brake pedal and the brake linkage under the dash with a single bolt.


either your parking brake is not released all the way or the switch needs adjusting


The engine computer through the brake light switch.The engine computer through the brake light switch.


Your fuse could be blown, or the brake light switch is improperly adjusted.


just behind the leg on the brake peddle


The switch is located up under the dash near where the brake pedal pivots. You will need to unplug the connector, press the pedal down and, rotate the switch counter clockwise to remove.


Could be failed brake light switch


probably a faulty or mis-aligned brake light switch.


How to change the brake switch on a 2004 Jeep grand Cherokee Laredo


there is an adjustable brake light switch under the pedal.



its not a switch its a fuse check the fuse and the light fuse is under the driver side dash look in your manual for brake light fuse



Check the brake light switch located on the brake pedal lever. If there is power to the switch but nothing coming out replace it. Did you check the bulbs? Is there power to the rear sockets?



Check the fuse, and the bulbs, then the switch on the top of the brake pedal


They aren't. The brake light circuit is not connected with the headlight circuit.


Brake light switch is located on top of brake pedal lever under the dashboard The brake light switch is mounted in the pedal support bracket and is operated by the pedal. Remove the steering column cover and lower the trim panel, if necessary. Disengage the switch electrical connection. Screw the switch out of the retainer, or rock the switch up and down, then pull it rearward out of the retainer. Installation is the reverse of removal.


it's probably the brake light switch. in front of the brake padle. have you check the brake switch. their not very expensive. at auto zone


Brake light switch might need to be replaced. Simpler answer would be a blown fuse.



check the fuse for the brake lights, they have thier own. also check the brake light switch at the at the top of the brake petal


Check the operation and/or alignment of the stop light switch usually located at the upper end of the brake pedal under dash area



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.