It it right beside the brake master cylinder.???Small round clear container and very easy to see.It is mounted on the firewall plain and simple.Just in case use dot 3 or dot 4 brake fluid in it if it low.If it is low that probably means the slave cylinder mounted on the right hand side of the transmission is leaking and should be REPLACED.If it is not replaced the truck will eventually not go into to any gear.Buy a haynes or chiltons manual for the truck(please) to learn the basics and it does cover how to do alot on these trucks.
No fluid in the master cylinder
NO, Break Fluid Only
use brake fluid
DOT 3 Brake Fluid
It is a triple rotor Rotary engine. A b2000 was there pickup.
The 1986 Mazda B2000 pickup truck has 14"x5.5" rims. The OE tire size is 205/75R14, and 195R14 tires also fit ideally.
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
where do you add clutch fluid on a Mazda 1997
205 75 14
Also,do you adjust them warm or cold?
There is air in the clutch hydraulic system. This can be because the Master or Slave is bad, low fluid level, or it was not completely bled after installing a Slave or Master. Usually this problem is caused by a bad clutch slave which has leaked out all of the fluid. Kyrasis6 Owner of Mazdatruckin.com
The Mazda b3000 pickup truck does not have hydraulic fluid. None of the vehicles components use hydraulic fluid in any way.