answersLogoWhite
Chrysler Sebring
Honda Civic DX
Honda Civic LX

Where is the ECM located in a 1997 Chrysler Sebring LX?

363738

Top Answer
User Avatar
Wiki User
Answered 2006-04-21 16:33:44

when looking from the front of your car into the engine compartment it is to the right of the air filter on the left of the engine fuse box that is below your positive jump start post.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


The PCM is located in the actual engine bay on a 2000 Chrysler Sebring. It is mounted vertically next to the battery tray.


It is on the passenger's side fender well under the air filter housing


The last Chrysler New Yorker was made in 1996. A 1999 Chrysler has computers under the hood and inside the vehicle.


The 1997 Ford Ranger ECM computer is located behind the dashboard. The computer will be on the passenger side of the passenger compartment.



The engine computer is inside the driver side fender.



you will find ECM center front (inside car ) on the floor hide by black plastic.


A fuse blows when the current in the circuit passes what the fuse is rated at. If you are blowing the ECM/starter fuse, the starter is probably bad.


Should be under the hood on the pasenger side.


where is the ECM located on my 2000 Jimmy? where is the ECM located on my 2000 Jimmy?


the pcm is located under the hood on the left hand side just left of the ecm


On almost all Concorde the ECM/PCM is located in the engine bay on the right hand side under the air filter box. The TCM is located in the engine bay on the left hand side near the battery.


The "governor" on this car isn't a part that can be removed. The vehicle's ECM is programmed to cut the fuel supply once the vehicle reaches a pre-determined speed. For my 2005 Sebring, that speed is set at 190 km/hr. In theory, it is possible to reprogram the ECM, and there are companies that offer power programmers for certain higher performance vehicles, such as a Magnum, or 300. However, to the best of my knowledge, no programmers are available for the Sebring. You'd have to be a programming genius, and rather stupid, at the same time, to attempt any kind of modification to your ECM on your own.


IT IS LOCATED INSIDE THE PASSENGER SIDE FENDER WELL BEHIND THE BUMPER COVER.


If the same engineand, if both either have theft alarm or neither have theft alarm then it may work.


Remove 20 Amp fuse in the power distribution center located in cavity B.


In the fuse holder , look at you owners manual.


It is in the fuse box. It will be a red 10 amp fuse.


the ecm is the ecu its located under the glove box well to the side were you place your feet there is some plastic by the door remove the one under the glove box and you will see it!


where is the ecm unit in a 1997 Chevy Malibu 3.1 6 cly


It's right beside the accelerator pedal.Just unscrew the panel and voila!


the ECM is located down below the center console


Where is the ECM located on ford expidition 4.6




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.