Hello,
Like a some people I, too wanted to know where the EGR Valve is located in my 1992 Plymouth Voger with a 3.0L engine. Other EGR valves are clearly visible with other Voyager engines (2.5L, other 3.0L, 3.3L & 3.8L)as stated in one of the popular repair manuals. I read in one of the websites today that there are 3.0L engines that do not have EGR Valves, reason - not needed (?). In another site someone stated that it is located behind the engine near the firewall - the complete air filter asembly has to be removed to see it. I also went to a national car parts chain store and asked if an EGR Valve is available for my vehicle, answer - no, it is only for vehicles designed for California emission.
This afternoon, I will explore behind my engine (since I will be replacing my oxygen sensor and doing a complete tune up due to the prices of gas nowadays)and hopefully I will not find an EGR Valve - one less parts to replace. I will try to contribute my findings later. Good luck to all!
AnswerHello again,As I promised earlier, I will contibute my findings - I am certain now that my 1992 Plymouth Voyager 3.0L does not have an EGR Valve. I thought it would give me comfort (one less part to replace) but instead it is now giving me a nightmare, I just brought my car for inspection and it failed because of slightly higher NOx reading, an EGR would have probably prevented this but, this is for another thread.
The 1997 Plymouth Voyager low pressure valve is located on the bottom of the air conditioner compressor. The low pressure valve has a hose connected to it.
If equipped, it is behind and to the passenger side of the throttle body.
in the front of the engine on the right side of the engine. next to the plenum. you will see a black hose that leads into a small metal valve that screws to the engind. if you pull the hose off you can remove it with a deepwell socket. not your average looking pcv valve.
105 in-lbs.
where is the fuel pump shut off valve for a 2001 Plymouth voyager
take it in
Perhaps it is your pcv valve or rubber elbow connector that is hooked up to the pcv valve.
There are seals under the valve cover that need replaced to repair oil on the spark plugs.
what year??old one like 90 and back in v cover 90 and newer in intake
You can't, there is an anti siphon valve in the filler neck.
There should be a small valve at the bottom of the rad.
You can't, there is an anti siphon valve in the filler neck