On the front passenger side corner of the intake. It has two wires.
The IAT is located on the side of the throtle body.
The O2 sensor should be located on the exhaust pipe, between the manifold and Cat. converter. It resembles a spark plug and attaches directly into the pipe.
The 1994 Jeep Grand Cherokee IAT sensor can be found attached to the air intake hose. The IAT sensor will be near the air filter box.
It is in the engine block area.
It is on the right front corner of the intake manifold. It has two wires and points out at a 45 deg. angle.
Where is the speedometer sensor located in a Jeep Liberty 2002?
The IAT, Intake Air Temperature, sensor is located in the air filter box. Look for it to be plugged in to the side of the air cleaner box with a wired connector going to it.
an intake air temperature sensor is a sensor that is used to measure the temperature of the air that flows through your intake manifold into your engine.it is usually posisioned on the intake filter housing.
On a 1990 Jeep Wrangler, the IAT sensor is located on the intake manifold. It is a gray, two-wire system situated on the front of the manifold.
The iat sensor is the front sensor on the intake manifold it has a gray 2 wire plug that is the 4.0 lt the 2.5 the sensor is the back sensor on the manifold.
JUST TO THE RIGHT OF THROTLE RETURN SPRING IT IS A 2 PIN PLUG.
on the intake
its right under the 2 mettal tubes that run over the engine the right where they turn right under that it runs into your block has 2 wires running from it
I think iat stands for intake air temperature --- if so then there will be a sensor mounted in the ducting between the air filter and the throttle