answersLogoWhite

0


Best Answer
Copy

You'll find the location for the 4 & 6 cylinder in this pic. http://autorepair.about.com/library/faqs/bl826b.htm

User Avatar

Wiki User

โˆ™ 2006-07-19 23:09:32
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the O2 sensor located in a 1992 Chevy Corsica?
Write your answer...
Submit

Related Questions

Where is PCV valve located on 1992 Chevy Corsica?

typically in the valve cover.


Where is the 1992 Chevy 1500 pickup cam shaft sensor located?

1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.


How do you drain the radiator on a 1992 Chevy Corsica?

The radiator drain on a 1992 Chevy Corsica is located on the bottom, left side of the radiator. It provides a quick and effective way to drain the radiator during maintenance.


Where is the radiator draincock on a 1992 Chevy Corsica?

It is located on the drivers side of the car on the bottom of the radiator


Where is the Ignition Module located in a 1992 Chevy Corsica?

The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is temp sensor located on 92 Chevy 3500 with 454?

The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.


How much time on average is to replace the timing chain on a 1992 Chevy Corsica?

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.


Where is crankshaft sensor located on 1992 Chevy lumina?

That year model did not use are have a crank sensor.


Where is the IAT sensor located on a 1992 Chevy truck 5.7?

The 1992 Chevy 5.7 liter engine IAT sensor can be found on the back of the engine. The IAT sensor will be near the top of the transmission.


Where is the speed sensor located on a 92 Chevy K1500?

The 1992 Chevy K 1500 speed sensor is located on the back of the transmission. The speed sensor will be in the upper right-hand corner of the transmission.


Where are the O2 sensors on a 93 Chevy?

where is the o2 sensor located on a 1992 Chevy s-10 4.3 ?


Is there a shut off on the gas tank on a 1992 Chevy Corsica?

No


Where is the fuel pump on a 1992 Chevy Corsica?

Fuel tank.


What is the firing order for 1992 Chevy Corsica 2.2?

1342


Location of crankshaft sensor for a 1992 chevy 1500 truck 4.3 engine?

The crankshaft sensor is located in the engine on a Chevy 1500 truck. This is under the hood.


Where is crankshaft sensor on a 1992 Chevy Cavalier?

its located at the rear of the engine (center) attached to the block


Where is the crankshaft sensor on a 1992 Chevy k1500 5.7L?

The 1992 did not use a crankshaft sensor.


On a 1992 Chevy lumina with a 3.1 eng where exactly is the crankshaft sensor located?

behind the harmonic balancer


How do you replace speed sensor on 1992 Toyota Previa and where is the sensor located?

How do i replace speed sensor on 1992 toyota previa and where is the sensor located


How do you install a serpentine belt on a 92 Chevy Corsica?

Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.


Where is the voltage regulator in a 1992 Chevy Corsica with a 6-cylinder engine?

IN THE ALTERNATOR


Where is the switch for the brights in a 1992 Chevy Corsica?

on steering wheel colum,the turn switch works it


How do you replace or repair the fuel pump on a 1993 Chevy Corsica 6 cylinder?

located in the fuel tank of a 1992 corsica ,it may be the same for your model if this is so you may need to drop the tank . I would notadvice you to take on this job unless you have to.


Where is the egr valve located on a 1992 Chevy Corsica 4 cylinder?

SIGN UP FOR ALLDATA.COM TO BE SURE. IT IS SO WORTH YOUR TIME AND TROUBLE. T HEMPLE there is no egr valve in a 1992, the manual says so


Where is the camshaft position sensor located on engine for a 1992 Chevy Corsica?

If you have the V-6 engine it is on the side of the engine block closest to the firewall just above the oil pan about 2 inches up and about middle of the block. This is the crankshaft sensor this car does not have a camshaft sensor On the 4 cylinder it is below the coil pack same side of the engine as the V-6. And again this is a crankshaft sensor not a camshaft sensor. Hope this helps