Best Answer

in the valve cover on the passenger side It is on top of metal intake, very close to throtle body. It is like 6" from a vacuum line coming from brake booster to the intake. on the intake, it is between the air idle control valve and the egr valve. u will see or feel the rubber hose sticking out of the rear of intake, the pcv valve is threaded into intake. the rubber hose is attached to it. according to manual, if u take off hose with car running, and there is a vacuum present, then valve is working.

User Avatar

Wiki User

โˆ™ 2005-08-05 05:53:55
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the PCV valve located on a 1995 Mercury Villager LS?
Write your answer...

Related Questions

Where is the BPA valve located in a 1995 Mercury Villager?

The BPA valve is located on the rear of the upper intake manifold just opposite the throttle.

How do you change the valve cover gaskets on a 1995 Mercury Villager van?

You will need to remove the valve cover from your 1995 Mercury Villager. Peel the valve cover gasket off of the valve cover. Clean the valve cover surface. Apply the new valve cover gasket.

Where is the oil leaking from in 1995 Mercury Villager?

Valve cover? Engine seal/ front or rear?

Where is the air relief fitting for 1995 mercury villager?

There is no such part on a Mercury Villager.

Where is the rear hatch release located on the 1995 Mercury Villager?

Under the edge of the tailgate.

How do you change timing belt on 1995 mercury villager?

timing belt 98 mercury villager timing belt 98 mercury villager

1995 Mercury Villager?


Where can you find your transmission on mercury villager 1995?

On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine

Where is the alternator located in a 1995 mercury villager?

The alternator is mounted down low on the back side of the engine.

Where is the location of Turn signal relay switch for Mercury Villager 1995?

The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.

Where is tha low pressure valve on a 1995 mercury tracers air conditioning system?

The low pressure valve, on your 1995, Mercury, is located on the top of the air conditioning compressor. The low pressure valve should be labeled.

Where is the neutrl safety switch located on a 1995 mercury villager gs?

It's part of the range switch on the transmission.

Does 1996 mercury villager transmission fit in the 1995 villager?

Yes, it should fit.

What refrigerant is used in a 1995 Mercury Villager?


What are the specifications on a 1995 Mercury Villager?

Buy a manual.

Can the PCM be adjusted in a 1995 Mercury Villager?

No, there is no "adjustment".

Where is the fuel filter located on a 1995 Mercury Villager?

under the hood, driver's side - attached to the firewall in a tension clip

Where is the mass air sensor located in the 1995 Mercury Villager?

Mass air flow sensor is mounted after the air filter.

Does a 1995 mercury villager have a heater hose control valve?

Yes you will have a heater control valve but try and locate one from other than the dealer because it will cost you around $135.00 dollars.........

Where is the A.D.L. link connection on a 95 mercury villager van with a 3.0L located?

The 1995 Mercury link connection is located on the bottom of the dashboard. The link connection will be on the passenger side of the dashboard.

What is the oil capacity for a 1995 Mercury Villager?

4.2 quarts

Where can you buy a center light for a 1995 Mercury Villager?


What is a pcm in a 1995 mercury villager?

Powertrain Control Module

What is the Spark plug gap for 1995 mercury villager?

1995 Mercury Truck Villager Van 3.0L EFI SOHC 6cylThe Spark Plug Gap.032 (In thousandths of an inch)

Where is the oil pressure sensor located on a 1995 Mercury Villager?

right above the oil filter on the transmission side of the filter mount