ITS HARD TO SEE BUT IT SHOULD AT THE REAR OF THE INTAKE ON THE PASSENGER SIDE OF ENGINE COMPARTMENT
1989 ford F250 Fuel Problems, It cranks but wont start
It is on the back of the valve cover on the passenger side very hard to get to though.
pass.side valve cover at the rear
how do you change out the distributor assembly on a 1989 ford f250
on top of the motor
The only 351 that ford offered in the F250 was the Windsor. The 351 windsor was put in the ford trucks from 1983 to 1986.
I don't know where you can get a diagram but Ford has some recalls out on duel fuel tanks. Check with a dealer yours could be covered.
in the valve cover left side and hooked to carb
Under the valve covers
It is located on the drivers side frame rail under the back of the cab/end of the bed area.
It could be done, yes.
i have the same engine in a 1984 e350 and i get about 8
The easiest way to tell is that the Windsor has trapezoidal valve covers with six bolts, whereas the Cleveland has rectangular valve covers with eight bolts. Also Cleveland has the thermostat housing on the front of the engine and the Windsor has it on the intake.
On my 1989 f250 the oxygen sensor is in the exhaust header pipe a few inches in front of the catalytic convertor
According to one of the Ford websites : For a 1989 Ford F-250 , 7.3 liter diesel engine : The ( Motorcraft FL-784 ) engine oil filter is used
Usually on valve cover with vac hose to carb.
how to remove rear axle from 1988 f250 ford
On your 1989 Ford Ranger : The vacuum modulator valve is on the passenger side of the A4LD automatic transmission ( it might be behind a heat shield )
on the back of the block on top of the bellhousing mount
sounds like a bad idle control sensor
On the Ford it is 3215469870. on the windsor it is 215698743
i have to change oil pump f250 351winsar.how topull the engine out?
To the left of the motor towards the back above the headers mine is a white color
1985-1988 ford f150 f250 and f350 or a 1994 f150 f250 and f350