The PCV Valve is located on the top right of the engine, which connects a tube from the intake manifold to the head of the engine. IT IS NOT THE ONE THAT CONNECTS TO YOUR INTAKE!!! ..
The PCV valve on a 99 GMC Yukon is found in the left valve cover. It allows trapped gases inside the engine to be recirculated and reused.
passenger side valve cover
The PCV valve on your car is mounted on the valve cover and has a rubber hose that is connected to the fresh air intake.
I would say that my 1998 S-10 does not have a PCV valve, at all, anywhere.
The PCV valve is located in the engine area on the 99 Volvo S80T6. It is important to carefully study the user manual which has an illustration of the same.
86 prelude pcv locationThe 1986 1987 Honda prelude pcv valve is in the middle under the intake. It has a hose running through an opening on the intake. It is only accessible by removing the intake. The intake is very hard to remove in the carbecause the bottom bolts are so hard to get to.
On the 3.5 engine, the valve is at the right back of the intake. On the 2.7 the valve is on the left front of the intake.
The PCV valve is attached to the intake by a hose and is located in the valve cover held by a plastic retainer on the passenger side of the engine near the power steering reservoir.
Mine's on the drivers side valve cover, towards the firewall.
On the top of the valve cover on the drivers side of the engine , near the rear of the valve cover
on 99 models with 1.8 liters on top of engine in center of valve cover
I have a 99 tracker 2 liter - I just replaced the pcv valve $15 Off of the manifold there are 2 hoses going to valve cover - One of them has a plastic L shaped pcv valve attached to it sticking in the cover Pull it out then replace and shove back in. If you buy the pcv valve you can visually ID it on the hose Good luck