The location of the block heater wiring in the vicinity of the driver side area between the firewall and strut tower under the hood. It is described as a flat, black, 3-conductor wire, tie-wrapped to other wiring. It may be wrapped with the plug and wiring in a bundle in that location, if not follow the wiring back to the plug. It's about 3' long. You can route the cord forward under the air filter housing and to the radiator. There's a rubber flap at the side of the radiator. Route the plug through the flap, then pull the cord down to the appropriate level. After unclipping one of the extra zip-ties you should have just barely enough slack to reach under the bumper between the fog light and license plate. It leaves the plug and about 0.5" of cord available for the hook up. Make sure to cap the plug when you're not using it to prevent ice from forming and coating the plug during freezing rain. The power cord must be secured in its retainer clips, and not positioned so it could contact linkages or exhaust manifolds and become damaged. Credit for this answer goes to ptcruiserlinks.com. For the source of this answer and for more info on the topic visit http://www.ptcruiserlinks.com/forum/general-pt-cruiser-discussions/13772-block-heater-newbie.html
The 2002 PT Cruiser block heater is located on the front of the engine block. You should be able to follow the block heater cord to the block heater.
If you are asking about a cord that looks like a black household extension cord, that is called a block heater. You can plug that cord in and it will slowly heat the coolant in the engine. They are mainly used in colder climates to help the vehicle start when the thermometer drops near and below 0 F.If you are asking about a cord that looks like a black household extension cord, that is called a block heater. You can plug that cord in and it will slowly heat the coolant in the engine. They are mainly used in colder climates to help the vehicle start when the thermometer drops near and below 0 F.
is it a big job to change a heater core on apt cruiser2001 limited
Did you ever have a coolant leak?
The heater core has failed.
The fuel filter is part of the pump module in the fuel tank on a PT Cruiser.
Platinum is a transition metal. It is in the d block.
in the middle of the steering wheel... push it
It is on the front of the transmission case. It is the block below the cooler hoses.
Try e-gunparts.com
The fuel filter on a Chrysler PT Cruiser is part of the pump module in the fuel tank.
The fuse of a 2006 PT Cruiser for the rear windshield wipers is located in the fuse box inside the dashboard. It is to the left of the steering column cover.