answersLogoWhite

0


Best Answer

Follow the 2 small metal lines from the side of the radiator to the transmission

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the Transmission coolant line located on a 1997 Dodge Grand Caravan 3.3 Liter motor Is the line made of rubber and metal?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would I have coolant pouring out a rubber elbow underneath the car?

are you sure it is coolant? is the elbow located on the firewall? if that's the case then it's not coolant, it's condensation from the AC doing what it is supposed to do.


Where is the transmission modulator value located on a 1990 buick regal 3.2 engine?

it should be on the side of the transmission with a black rubber tube from the engine leading to it


Where is the transmission dipstick located on a 1995 Mazda Protege?

It's located between the battery and the air intake. The top is black rubber not yellow.


Where is the transmission dipstick on a 2000 Cadillac Seville?

when you open up the hood of your car look to the right side of the engine block, and there should be a black rubber tube with a plastic shroud covering it located right in front of the coolant tank. this is the air filter housing and will need to be removed by unclipping the 2 clips and one ring that hold it in place. also make sure to disconnect the sensor located on the rubber tube. after that has been removed under where it used to be should be a dipstick for the transmission fluid. and on a side note if your transmission fluid is dark yellow to brown, get it changed immediately!


Where is the transmission dipstick on a 2000 Seville?

when you open up the hood of your car look to the right side of the engine block, and there should be a black rubber tube with a plastic shroud covering it located right in front of the coolant tank. this is the air filter housing and will need to be removed by unclipping the 2 clips and one ring that hold it in place. also make sure to disconnect the sensor located on the rubber tube. after that has been removed under where it used to be should be a dipstick for the Transmission Fluid. and on a side note if your transmission fluid is dark yellow to brown, get it changed immediately!


Where is the transmission fluid fill located on a 1996 Mitsubishi eclipse gs with a manual transmission?

It is a rubber stop with a little rubber piece you have to pull, located on the side of the transmission under the battery. you will need a very long and flexible funnel to fill it and when you do fill until the fluid is level with the bottom of the hole. around 2.5 qts i believe. Very hard to find, took me hours.


Could there be aleak in coolant tube?

Yes, there could always be a leak in coolant tubes. Most tubes are made from rubber and rubber + old age = cracks and stretching


Where is 96 Acura intergra speed sensor?

It's located on the transmission. Look close it's under rubber hose. That's a manual transmission vss speed sensor location.


Where do you find the clutch slave cylinder on a 1998 Chevrolet Cavalier?

the clutch slave cylinder on this car is located inside the transmission itself. The part has a rubber bushing that separates the the hydraulic lines and bleeder, from the section that is located in the transmission housing itself.


Where to fill transmission fluid in a 2000 land rover freelander?

Fill up tube is located on top of the transmission next to two electrical connectors. It has rubber plug need to be pulled out first.


Where is the CV axle 1996 Honda Accord?

It is located an axle that connect your wheel to the transmission. If you look under the car, it is the part that has two rubber "boots" on both ends. one end is by the wheel, the other, in the transmission


Where is the low coolant sensor on a 1996 buick skylark v6 located?

Look at the coolant tank and toward the front there is a plug the connects to a sensor at the bottom of the tank. There is a float in there that will stick to the bottom even with the correct amount of coolant. I used a rubber mallet to tap the tank and got the sensor to free up. Good luck.