it's on the intake manifold.
on the top of the differential
The sensor is in the intake manifold (MFI engines) or air cleaner/tube (SFI engines).
on the intake manifold on the driverside.
It is located on the intake manifold next to the fuel rail.
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
the tail shaft of the tranny on the speedo cable
what eng. do you have? if it is a 5.4 or a 4.6 it is under the intake manifold on the passenger side.
It is in the intake air horn from the air filter to the throttle plate.
how to replace an oil pan that goes to a ford f150 1993? how much does the pan cost,and can you show a picture of it?
On a 2004 Ford F150, the vehicle speed sensor is located on the driveshaft of the transmission. Some models of 2004 Ford F150s use an ABS sensor instead of a vehicle speed sensor.
i may be wrong so call your local dealer, i believe is on the transmission
Wher is the o2 sensor on a 2006 ford f150
Its on or in the "tube" going from your air filter to intake. It will be on the engine side of the air cleaner assembly.
Yes it does. It is on the intake side under the cylinder head below the intake plenum. You have to take the intake manifold off to get to it.
It stands for IAT sensor 1 Circuit High Input basically there is either a shortin the wiring or the sensor is bad. It is a sensor for intake air temperature and it will effect idle and misfire
The temperature sensor is located in the lower intake manifold. The air temperature sensor is located on the right hand side of the engine well against the wall just behind the battery.
The intake on the 1979 Ford 302 engine is different than the intake on the 1993 Ford 302 engine. The intakes are not interchangeable.
I believe it is located on the left side accross from the front spark plug. It is under the intake. you have to look close. that is where it is on my six. i am not sure about an 8
It is on the intake side of the cylinder head underneath the intake manifold which has to come off to access it.
There is no OBDII connector on 1993 F150. Didn't start until 1996 (97 model).
The air temp sensor is in the intake manifold, in the cylinder number 6 intake runner (drivers side, second cylinder from the front) in the lower intake manifold. The plug should have a yellow wire and a black wire.
Which Sensor are you refering too?