Cooling SystemEnsure that the engine is completely cool prior to starting this service. 1. Remove the recovery tank or radiator cap. 2. Raise and support the vehicle. 3. Place a drain pan of sufficient capacity under the radiator and open the petcock (drain) on the radiator. è Plastic petcocks easily bind. Before opening a plastic radiator petcock, spray it with some penetrating lubricant. 4. Drain the cooling system completely. 5. Close the petcock. 6. Remove the drain pan. 7. Lower the vehicle. 8. Determine the capacity of the cooling system, then property refill the system with a 50/50 mixture of fresh coolant and distilled water. 9. Leave the recovery tank or radiator cap off to aid in bleeding the system. 10. Start the engine and allow it to idle until the thermostat opens (the upper radiator hose will become hot). The coolant level should go down, this is normal as the system bleeds the air pockets out of the system. 11. Refill the system with coolant to the proper level. 12. Turn the engine OFF and check for leaks.
A 50/50 mix of Green antifreeze and distilled water.
According to the 2000 Ford Expedition Owner Guide : It came from the factory with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
How do you change the antifreeze in a 2004 Eddie Baurer ford Expedition.
Antifreeze has to be put in at the overflow bottle.
Drain and remove the fuel tank to gain access to the pump.
the one the AC drain leaks on to
There is a hole where the fluid is running out at the bottom of the car. Can this part be replaced easily?
Where is the airbag module on the 2000. Ford expedition
wheren is the horn relay on 2000 ford expedition
According to the 1999 Ford Expedition Owner Guide : It came from the factory with a 50 / 50 mix of distilled water and GREEN color antifreeze ( meeting Ford specification ESE-M97B44-A )
How do you replace the ignition switch on a 2000 ford expedition?
( 5 per wheel ) on a 2000 Ford Expedition