0
Where is the belt drive failure fuse for a 03 kawasaki prairie 360?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Installing drive belt for 1999 Kawasaki Prairie 400 4X4?
To install drive belt on a 1999 Kawasaki Prairie 400 4x4, access the engine area and remove the cover that holds the clutch. Remove the drive belt around the clutch at the right side of the engine. Replace with new.
How do you change kawasaki 360 prairie drive belt?
Remove side cover, remove clutch ( primary the smaller clutch) and belt will come off easy. Make sure to install new belt with arrow on belt pointing in the right direction (forward)
How do you adjust the drive belt on a 610 kawasaki mule?
Take it to your nearest certified Kawasaki dealer...
Where is the VIN on a Kawasaki Prairie 650'?
I believe its on the right side of the bike. Just below the belt cover.
What mileage to change drive belt in peugeot 206?
The drive belt on a Peugeot 206 should be change in 80,000 miles. Failure to change drive belts at the appropriate time can result in expensive engine failure.
How do you replace the drive belt on a kawasaki mule 2510?
You need a special tool from Kawasaki to hold the drive pulley. The Kawasaki part number for the tool is 57001-1520. After you remove the convertor cover. You remove the drive pulley by bolting the tool on the three upper bolts then take off the drive pulley nut (left hand threads). Once the pulley is off take the belt off the driven pulley then you can reinstall the new belt. You also have to check the belt deflection. Put a straight edge from the belt on the drive pulley to the belt on the driven pulley. Using a ruller push down on the belt. The deflection should be no more than 1". If it is I would take the ATV to a Kawasaki dealer. They will need to add or subtract springs and shims from the drive pulley. If the old belt has never been change you might be OK by just replacing it. I have not tried to take the drive pulley off without using the special tool from kawasaki. The best thing you can do is go to RepairManuals.com and look up a KVF650 2003, you can buy the OEM repair manual for $60.00 plus about $6.00 shipping. It has saved me a lot of money.
What is the gas mileage of a 1982 kawasaki kz440 ltd?
I get a consistent 58-60 mpg with my '82 kz440 belt drive.
How to Adust drive belt on Kawasaki 550 Mule?
Adjusting the drive belt on a Kawasaki Mule requires a specialized tool only available to dealer mechanics. The belt should have no more than one inch of deflection when pushed down. Any more will require adjustment of replacement. Replacement can be done by removing the converter cover. Disconnect any wires that may be (with some models) present. Remove the drive pulley and belt. Replace belt and check for deflection. If more than one inch is present, shims will need to be added or subtracted, which requires a dealer.
What causes power steering failure when turning?
No/low steering fluid, loose drive belt, crushed or blocked hydraulic pipe, pump failure
How do you tighten belt on kawasaki brute force?
how do u tighten belt on brute force 750?
Where is the Blackland prairie located?
The blackland prairie area lies to the west of the post oak belt.
What is a serpentine belt also known as?
Accessory drive belt.Accessory drive belt.
