0
It is on the pipe behind the engine that goes to cabin radiator
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you bleed the coolant system on a 2002 impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
How do you Bleed the coolant system on a 2002 Chevrolet Impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
Where is coolant bleed screw on 1997 grand prix gt?
The bleeder screw for the coolant system is on top of the motor, tword right side of the intake manifold. It should look like a nut with a flat head screw in it on a piece that goes into the motor.
How do you bleed all of the air out of the cooling system on a 1995 Pontiac Grand Am with a 3.1?
on the side of the thermostat housing there is a small screw with the motor is running make sure the heater is on loosen the screw let the water run until you see a steady flow then tighten back up. I disagree with the previous poster. The cooling system is bled by loosening the screw on the metal pipe just behind the water pump housing. The pipe goes upward off the housing and has a bleed screw on the end of it. To Bleed the cooling system, turn the heater to full hot and open the screw and add coolant to the resevior until you get a bubble free flow of coolant from the bleed screw. At this point the system is bled and just tighten the screw.
How do you bleed coolant on a jaguar x-type?
It bleeds automatically. There is no bleed valve or screw and no bleeding is necessary.
How do you bleed air from the cooling system of a Pontiac Grand Am?
It should be a bleeder screw connected to the cooling system, it might be two.If you find it,you should open one at a time.Pour coolant into the system slowly,until coolant start coming out of the bleeder screw and then close it . DO it to the second screw too.Now if you do not have the bleeder screws.Pour coolant into your system slowly and squeeze the top hose until no bubbles come out and the coolant level should go down at this time and then pour alittle more in there
How do you bleed the coolant system on a 2004 Chevrolet express 3500 van?
You have to use a radiator funnel kit from napa part # 77-4000 runs about $20. Chevy vans do not have a bleed screw.
How do you bleed air from the cooling system of a Chrysler Concorde?
The bleed screw is by the thermostat housing it looks like a brake bleed screw
Where is the bleed thumb screw on a 2000 Lincoln ls?
Next to the coolant reservoir... black hose sticking forward with a plastic screw in it...
How do you bleed the air out of the coolant system on a 2000 grand am?
when it is cold take the cap off the radiator and start the car and let the air out The above answer is incorrect. The cooling system on the Grand Am requires you to bleed the system. There is a bleeder screw on the top of the motor, just follow the black tubing and you'll see it.
1988 Acura Legend bleed cooling system?
How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?
Where is the location of an Audi a4 coolant bleed screw?
Under the plastic engine cover midway along the rail carrying coolant - opened with Allan key
