It is located on the clutch slave cylinder. The slave cylinder is mounted on top of the transmission. Have someone push on the clutch cable and you will see movement on the cylinder.
how much cost to change a clutch for a geo prizm 1995
If you mean the coolant bleeder valve, it doesn't have one.
No, it does not.
You bleed the skave cylinder just like your brakes. Pump a few times hold and open the bleeder valve and repeat.
fill the clutch resivoir pump the clutch pedal open the bleeder screw and tighten it back up and repeat until the air is out and just fluid comes out
Fill Master cylinder Open bleeder on slave cylinder Let fluid run from slave Close bleeder install hose to bleeder on slave Run other end into container partially filled with fluid Have assistant step on clutch Open bleeder Observe fluid running into container Repeat until fluid runs clear (No air bubbles) Tighten bleeder securely
Just find the cable on the transmission and look at it. The adjusting nut is where it connects to the tranny. You'll have to figure out which way to turn it for yourself.
just bleed it like you would your brakes, the bleeder valve should be right on it, you could replace it with a speed bleeder to make it easier, or use a vaacuum pump
Crawl under the vehicle and locate the slave cylinder it is usually on the passenger side of the clutch. there is a fluid line and 2 bolts. First remove the hydralic line and then the 2 bolts and the slave cylinder will fall right out. Installation is in reverse order. then get a helper to bleed the clutch. First have the helper pump up the clutch and then you crack open the bleeder valve on the slave cylinder. Remember don't let the reservoir go dry Keep doing this process until you get the clutch you like and top off the reservoir and put the cap back on the reservoir
where is the vacuum diagram located on 1995 geo prizm
geo prizom 1995
This might be helpfful. How do you Change a fan belt on 94 prizm?