answersLogoWhite

0


Best Answer

The coolant bleeder on the 3.5L is on the thermostat housing on top of the engine.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the bleeder valve located on a 1996 chrysler lhs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the brake bleeder valve located in a 1996 Saturn Sl2?

The bleeder valve is a 8mm bolt for the rears located on top of the drum or on the caliper itself if you have disk rear brakes. For the front, a 10mm bolt is located on the caliper itself. PB blaster should be used to be sure the bleeder valve is not broken


1996 sedan deville where is the bleeder valve located to bleed air out of the coolant line?

If there is one - it should be located in the top of thermostat housing


Where is the slave cylinder bleeder valve located on a 1996 Nissan maxima?

It is located near on the transmission, I believe it'snear the motor mount. You will have to get under the car to find it.


Where is the clutch bleeder valve on a 1996 ford f150?

The hydraulic bleeder valve should be located on the drivers side (left) of the transmission up in a little hole with a rubber cover over the bleeder screw. Do not over tighten the screw or you will break it, then you would have to drop the transmission to replace it. Good luck.


1996 jimmy evap purge valve sensor where located?

where is the evap purge valve located in a 1996 jimmy


Where are the coils or coil located on a 1996 Chrysler sebring convertible?

The coil for the four cylinder is on the top of the valve cover. The coil on the six cylinder is inside the distributor.


Where is the shift modulator on a 1996 Chrysler located?

Chrysler does not use modulator valves.


Where is the egr valve located on 1996 Mitsubishi galant?

The EGR Valve on the 1996 Mitsubishi Galant is located underneath the Exhaust Manifold.


Where is the bleeder valve for the hydraulic clutch on a 1996 ford escort?

The bleeder valve is on the front of the clutch housing. There is a metal line that goes from the firewall master cylinder to the slave cylinder. The metal line goes across the transmission. Follow it and you will find a bleeder screw with a rubber cover on it. Take the cover off to bleed the system.


Where is the reset switch located on a 1996 Chrysler LHS?

A Chrysler LHS does not have a reset switch.


Where is the fuel pump reset switch on a 1996 Chrysler cirrus?

On a 1996 Chrysler Cirrus where is the fuel pump reset button located


Where is the expansion valve on a 1996 maxima located?

No