I am looking for the same thing, but 2001. My pathfinder getting overheat after about 10 minutes of driving, however when it is idling on parking the temperature stays perfect.
I found one thing that look like a bleeder valve in 2001 pathfinder. It is located right behind the engine, look like a straw with a rubber cap on it.
The bleeder valve for fuel injection for 1986 Nissan 300ZX is located at the furthest end of the fuel rail.
Where is the coolant bleeder valve located on a 2003 nissan maxima 3.5
it will be on the intake manifold.
swirl valve is located cloce to throttle body has two vacuum tubes
If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
Doesn't have a cooling system bleeder valve.
It is located near on the transmission, I believe it'snear the motor mount. You will have to get under the car to find it.
The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
The EGR valve is located on the driver's side of the engine on a 2001 Pathfinder. It is near the throttle body.
with a wrench
There is no bleeder valve in the heater system of that vehicle.
The bleeder valve is a 8mm bolt for the rears located on top of the drum or on the caliper itself if you have disk rear brakes. For the front, a 10mm bolt is located on the caliper itself. PB blaster should be used to be sure the bleeder valve is not broken