Want this question answered?
where is de bloc heater on the tucson 2009
There is none on that car.
To normally install a block heater you must remove an expanstion/ freeze plug in tighten in the block heater. The 6 cylinder 4.2L engine unfortunately does not appear to have any such plugs. The V8 engine should have a screw in style block heater installed in the left front of the engine block just below the cylinder head.
It is wrapped up under the rad on the drivers side of the engine compartment just in front of the power steering cap.
It alredy existed -BOOM- Goes the dynamite
where is the oil filter located on a 2009 chevy malibu?
Possibly. If it has a block heater the cord will be somewhere on the front of the car, easily accessible. Unless it is a Canadian car or it was ordered as an option it will not have one.
The 2001 Hyundai Santa Fe does not have a factory block heater option. Beginning in 2009 there is a port to install a Hyundai manufactured block heater for cars built for sale in Canada. Pre-2009 requires a heater to go in a freeze-plug hole, so the cord is wherever the installer put it, usually behind grille.
Heater motor speed resisters are usually located close or nearby the heater motor.
I had one and kept it in the trunk until it was needed
It is tucked up in front of the radiator you have to reach in from the front of vehicle
the temp sensor is located on the right side of the engine under the intake manifold on the engine block. Easiest access is from underneath. Location on engine: no special tools is need it to remove it