0
Under the glove box and air bag. Remove the airbag fuse and disconnect the battery before attempting to remove the blower motor.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
1998 olds intrigue Blower motor does not work in low?
Either it's the switch on the dash (unlikely) or the blower motor resistor pack (very likely). The resistor pack is usually easy to replace.
Where is the blower motor resistor on a 2002 Oldsmobile Intrigue?
It is on the evaporator case and is held in with 2 screws.
Where is the blower motor fuse on a 98 Olds Intrigue?
ITS IN THE FUSE BOX. THERES TWO OF THEM, ONE IS LABELED TOP BLOWER AND THE OTHER LOWER BLOWER.
Where is the blow motor resistor for a 1998 olds aurora located at?
The blower motor resistor is generally located close to the blower motor.
Where is the blower resistor on a 2000 Olds Intrigue?
It is under the dashboard against the firewall. You have to remove the blower motor first by folding yourself up into a ball, but it can be done.
The heater on your 99 olds intrigue is squealing and no hot or cold air will come out what will fix it?
Pull the blower motor out and check both the motor, the blower wheel and the housing for any trash that may be stuck in it................
High blower stays on even when the key is turned off......please help 98 OLDS INTRIGUE?
replacing the blower motor resistor which cost about 20 bucks or so.....hope this helps
Where is the blower motor resistor on a 1998 Olds?
its under your fuse panel on the fire wall there is to nuts to remove
Ac heater blower keeps running even when the power is off.olds intrigue 98'?
Well i heard plenty of reasons but the one that actually worked for my olds intrigue 98' was replacing the blower motor resistor which cost about 20 bucks or so.....hope this helps
Where is the blower motor resistor for a 1998 olds aurora located at?
Probably in the fuse box located underneath your hood.
How do you change 1998 Olds Intrigue?
Change what?Change what?
How do you replace the windshield wiper motor on 1998 olds intrigue?
Should be able to access under hood at center firewall plastic panel may have to be removed
