0
It is under the dashboard against the firewall. You have to remove the blower motor first by folding yourself up into a ball, but it can be done.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the blower motor resistor on a 2002 Oldsmobile Intrigue?
It is on the evaporator case and is held in with 2 screws.
How to replace blower resistor in 2002 olds intrigue?
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
1998 olds intrigue Blower motor does not work in low?
Either it's the switch on the dash (unlikely) or the blower motor resistor pack (very likely). The resistor pack is usually easy to replace.
High blower stays on even when the key is turned off......please help 98 OLDS INTRIGUE?
replacing the blower motor resistor which cost about 20 bucks or so.....hope this helps
Ac heater blower keeps running even when the power is off.olds intrigue 98'?
Well i heard plenty of reasons but the one that actually worked for my olds intrigue 98' was replacing the blower motor resistor which cost about 20 bucks or so.....hope this helps
How do you replace the blower resistor on a 2000 Olds Intrigue?
Disconnect the battery negative cable. !!!Power is still on when ignition switch off!!!I have Olds Intrigue 2000. Blower control resistor (Controller) located behind theblower motor. Very close to the firewall, and it is a pain in the neck to get there.Using 5.5 mm. socket remove the blower first. (3 screws are holding the blower)Using the same socket (5.5 mm) remove one visible screw which holds the resistor.You will have to loosen two other screws located between the resistor and firewall. You don't need to remove them completely, just loosen them! Resistor just slides outwhen they loose.---------------------------------------------------------------------------------------------------------Disconnect the battery negative cable.Remove the RH instrument panel insulator retainers. Adjust the carpet for access.Disconnect the courtesy lamp from the instrument panel insulator by turning 1/4 turn counterclockwise.Remove the RH instrument panel insulator.Disconnect the electrical connectors from the blower motor resistor.Disconnect the blower motor resistor electrical connector from the blower motor.Loosen, do not remove, both forward screws. The blower motor resistor opening is slotted as access is extremely limited.Remove the rearward screw.Remove the blower motor resistor.
Where is the blow motor resistor for a 1998 olds aurora located at?
The blower motor resistor is generally located close to the blower motor.
Where is the blower motor fuse on a 98 Olds Intrigue?
ITS IN THE FUSE BOX. THERES TWO OF THEM, ONE IS LABELED TOP BLOWER AND THE OTHER LOWER BLOWER.
Where is blower motor resistor on a 1999 Olds Intrigue located?
Disconnect the battery negative cable. !!!Power is still on when ignition switch off!!! I have Olds Intrigue 2000. Blower control resistor (Controller) located behind theblower motor. Very close to the firewall.Using 5.5 mm. socket remove the blower first. (3 screws are holding the blower)Using the same socket (5.5 mm) remove one visible screw which holds the resistor.You will have to loosen two other screws, located between the resistor and firewall. You don't need to remove them completely, just loosen them! And it is a pain in the neck to get there!!!Resistor slides out when rear screws are loose.--------------------------------------------------------------------------------------------------------AnswerThe resistor is under the glove box behind the blower motor. The motor is actually connected to the resisitor and the other connection on the resisitor comes from the climate control and relays. The part is right against the fire wall making it hard to get to. You need a socket and much patience to remove it. Good Luck.
Where is the blower motor resistor for a 99 Olds Intrigue?
Hi, I just replaced the resistor on my '98 Intrigue- it's quite possible they are located similarly. The resistor is located under the dash on the passenger side, right behind the blower. I had to pull the blower out to gain better access to the resistor assembly. There is a short cable assembly that connects the resistor to the blower so if you look for the two wires that come out of the back of the blower they should lead you right to the resistor. The resistor is very hard to get to because of the hex head screws being right up against the floorboard but you only need to loosen the two back screws and remove the one in front to be able to pull the resistor assembly out. If you can get a small 5/16" socket on the screw heads you should be able to loosen them enough. There will be a larger cable assembly plugged into the resistor also. The whole procedure took me about a half hour, not a bad job but just hard to maneuver down there. !
What type of freon does a 2000 olds intrigue use?
134a
What car uses the same alternator as Oldsmobile intrigue 2000?
Only the Olds Intrigue with the 3.5 L
