0
The fan will always have power under normal conditions when on. The speeds are controlled by the resistor based on the fanf switch position. The resistor is located on the black plastic fan cover under the dash and behind the glove box. The cable harness goes right into it. Follow it. Remove the screws and the resistor side of the assembly is facing the air duct side of the fan compartment. Be sure to have the a/c off when working or you may damage something or burn yourself with the resistor.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the blower motor resistor located on 2008 Nissan Sentra?
They are generally found close to the blower motor.
Where is the blower motor resistor in a 2008 Nissan sentra?
to the right of the gas peddal
Why does your 1997 Nissan Sentra blower works only on position 4?
Defective blower motor resistor pack.
What do you do if your 1998 Nissan sentra blower motor only blow on high speed?
More than likely the blower motor speed resistor burned out.
1995 Nissan Sentra blower motor resistor installation?
Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.
What causes an ac-heater in a Nissan Sentra to only blow on high?
you need a new blower motor resistor
Where is the Blower motor on a Nissan Sentra?
The Nissan blower motor can be found in the engine compartment on the firewall. The blower motor will be on the passenger side of the firewall.
Where is the blower motor resistor located on a 2001 Nissan Quest?
The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
Where is the 1995 Nissan maxima blower motor resistor is?
The blower motor resistor is mounted next to the motor on the passengers side under the dash..............
How you change the blower motor resistor in Nissan maxima 2002?
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
How do you replace the blower motor resistor?
I do not know what vehicle you are referring to but I just replaced one on a 1996 Nissan Sentra because the only speed that was working on the blower motor was 'high'. Underneath the glove box was a couple of screws that came out and the new resistor was put in. Two screws and done......... Most blower motor resistors are located close to the blower motor.
How can you figure out which to replace the blower motor or blower motor resistor on a 1994 Nissan altima?
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
