I just replaced mine last weekend.
The controller is $58 at Ford. Skip your local auto parts store search. They won't have it.
Facing the firewall: The controller is to the right of the A/C cooling tower. It's in the plastic shroud.
Remove the inlet and return hoses to your heater core for easy access. Above that there is a round electrical device. Remove that too. 2 screws.
2 Screws hold the controller in place.
It's an easy fix.
Check/ replace the blower resistor. Located in the duct work under the hood. Follow the wires from the blower motor to a plug on the duct work. This is the resistor
right adjacent to the flux compassetor.
crown Victoria blower not working and head lights.
the heater blower resistor is bad. located on firewall under heater hoses two 8mm bolts. about a twenty dollar motorcraft part. easy repair.
The blower is a multi speed unit.
where is the DPFE sensor located on a 2002 ford crown victoria?
Fuel pressure regulator located on 1998 crown Victoria 4.6 litter
the fuel pump on the crown Victoria is located in the gas tank and if replacing it you have to remove the tank to get to it...Dennis Sison
I have not worked on your model, however, most of the resistors are accessable once the glove box door is removed. I suggest you buy this part from your Ford dealer and then ask them to print out the picture of the resistors location for you. I hope this helps you. Mark If you look to the right of the blower box between the engine and blower box you will see two screws going into the evap core container. The blower motor resister actually sits recessed into this.... http://www.p71interceptor.com/blowerresistor/replace/ Scroll down and you will see
A 1997 Ford Crown Victoria engine is fuel injected so there is no carburetor
how do you get to the flapper for ford crown Victoria
where is the fuel pump relay located on a 1987 ford ltd crown Victoria