on the bulk head just above / behind the brake pedal. Should be a white plastic switch with two wires coming out the bottom
Probably cause by a worn out/defective brake light switch.
the brake lights are on a separate cuircut,if your brake lights are staying then it will be a fault with the brake light switch. the switch is located under dash,and will be on or very close to brake pedal.
Bad brake switch. Typically located at the top of the brake pedal.
It will either be a mechanical switch located on the brake pedal lever under the dash, or a pressure switch located on or near the master cylinder.
Look at the uper end of the brake pedal under the dash area
If you mean the switch that puts the brake lights on and off when you step on the brake pedal then it's located where the brake pedal is, can't miss it.
Defective brake light switch, or it is out of adjustment. Located on the brake pedal arm. there is a recall on the brake lite switch , check your local dealer..
If by 'controller' you mean the switch that makes the brake lights come on, it is not in the trunk. It is located underneath the dashboard, next to the brake pedal.
Just check your brake lite switch which is located at the brake pedal the switch might be broken that is why your brake lite is always on.
The brake light switch is stuck or out of adjustment. If it is a mechanical switch it is located somewhere on the brake pedal swing arm. If it is a pressure switch it is located near the Master Cylinder.
replace your switch, located under the brake pedal.
The brake light switch on a Nissan is located just behind the brake pedal. It sends a signal to the brake lights when the pedal is pressed to turn them on.