0
Where is the cam sensor located in a 4.0 engine in a 1996 Jeep Cherokee Laredo?
Wiki User
∙ 14y ago
It is in the distributor.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the crank sensor on a grand Cherokee Laredo 4.7 engine?
Usually a crankshaft sensor is located on the bellhousing of the transmission
Where is the temperature sender located on a 2002 Grand Cherokee Laredo 4.0?
The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.
Where is the output crank sensor located on a 1995 jeep Cherokee grand Laredo?
in a toilet
Where is the crankshaft sensor on a grand Cherokee Laredo with 4 L engine?
The crankshaft position sensor is on the top driver side of the transmission bell housing.
Where is the oil pressure sensor on a 1997 Jeep Grand Cherokee Laredo?
The oil pressure sensor on a 1997 V8 is on the top rear of the engine next to the distributor.
Where is the lift gate sensor located in a 1996 V-6 Jeep Grand Cherokee Laredo?
Its the lock/latch mechanism
Where is the crank position sensor located on a 96 Jeep Grand Cherokee Laredo?
It is on the top passenger side of the bell housing.
Where is the Crankshaft Position sensor located on a 1991 Jeep Cherokee Laredo?
paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor
Where is the speed sensor located on a 1989 jeep Cherokee Laredo?
Look on the back on the transfer case. There should be one wire running from it. That's your speed sensor. -- Blake.
Where is the camshaft positon sensor located on a 2003 Jeep Grand Cherokee Laredo 4.7 v8?
Under the front of the passenger side cylinder head.
Diagram of where the crankshaft sensor is located in a 94 jeep grand Cherokee Laredo?
No diagram is needed. It will be on the top left/right transmission bell housing.
Where is the vehicle speed sensor Jeep Gand Cherokee Laredo located?
Pre 1998, it is on the back of the trans/transfer case After 1998, it is the rear axle abs sensor on top of the rear axle.
