THE CAM POSITION SENSOR IS PART OF THE DISTRIBUTER, AND CANNOT BE SERVICED
No, It will only fit Toyota 4efe (starlet), 5efe(paseo), 5efhe(sera). 4afe is a different head.
To turbo a 5efhe your best option would be to Forged roads for a normal 5efe Forged Piston's for a 4efte Manifold to suit a 4efte turbo to suit manifold Downpipe to suit turbo Oil sump and oil filter housing off a 4efte 4efte rocker cover and inlet (makes pipework easie) Use engine loom from a 4efte and ecu from a 4efte Gearbox and shaft are of the same size the 4efte shafts have bigger cv joints on them.. This is the basic there is loads more you can do for more power etc :) Hope this helps
3e-e, 5efe, 5efhe, 4efte, 3ete, will all bolt up and be the cheapest. a 4age, 4agze, or 3sgte will fit with some frame modifications. basically you can put in any motor that will fit in the engine bay if you got enough cash.
The MAP sensor is located on the engine compartment on 1988 Toyota Corolla. The MAP sensor can be purchased at any auto parts store.
O2 sensor in the exhaust manifold near the engine
The 2006 Toyota coolant temperature sensor is located on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
the temperature sensor on the 1995 Toyota Tacoma is located on top of the engine on the front. It is beside of the thermostat housing and screws into the intake.
the sensor is under the exhaust manifold at the rear of the engine
The 2003 Toyota Tacoma 3.4 liter engine IAT sensor can be found on the left-hand side of the transmission. The sensor will be where the transmission meets the back of the engine.
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
The 2002 Toyota Tacoma 3.4 liter engine IAT sensor is located on the outside of the air cleaner housing. The sensor is on the back of the housing.
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
where is the speed sensor located on 2003 Toyota matrix
It should be in the side of the engine facing the firewall.
The camshaft position sensor is located under the hood, beneath the engine cover. The engine cover must be removed with a wrench to access the two sensor banks and their wiring harnesses.
The O2 sensor on a Toyota Corolla is located on the exhaust manifold. The O2 sensor properly reads the air fuel ratio to tell the engine how much fuel to use.
the sensor is right next to a radiator cap at the bottom of the neck.
The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.
the coolant sensor is at the back of the motor on the passenger side
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
the 92 4afe toyota engine does not have a crankshaft position sensor
you have to remove the intake and it is located inside the engine block,you can see it once you remove the intake........
They were used on the 1992 - 1996;Engine: 5SFEChassis: SXV10
It is located in the front of the engine on the cylinder head. It's located on the passenger side of the vehicle.