On a 1996 Ford Explorer :
4.0 litre EFI , V6 engine :
From what I have read the camshaft position sensor is on top of the engine ,
about the center line , at the rear of the engine near the firewall
You can't see it with the " plastic " intake manifold installed
The MAP sensor on a 1996 Ford Explorer 5.0 is located on top of the engine near the throttle body. It is bolted to the engine and also has a wiring harness attached to it.
Ford did not start using knock sensors on the Ford Explorer engines until 1996, when they switched to the EEC-V system.
Where is the tensioner located on a 1996 Ford Explorer V6 XLT?
The 1996 Ford Explorer overdrive sensor can be found on the right hand side of the transmission. The overdrive sensor will be near the front of the transmission.
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
On my 1995 Ford Explorer - 4.0 L - OHV - V6 , the intake air temperature sensor is in the big rubber air intake tube , facing to the rear , near the throttle body . A 1996 - V6 - should be the same
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
On a 1996 Ford Explorer : The power distribution box is located in the engine compartment , on the drivers side
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
i don't know the answer
there are several sensor, you can go to autozone.com and find out where they are