I have the same engine in my 1995 Ford Explorer :
I can't see the camshaft position sensor but from what I have read it is on the
top of the engine , near the center line , at the back of the engine near the
firewall
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
Inside the distributor
That year did not have 1
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
its mounted on the oil pump assembly behind the belt cover its mounted on the oil pump assembly behind the belt cover
I'm not a mechanic / technician but from what I understand the camshaft position sensor on the Ford 4.0 liter EFI , V6 engine is on the top of the engine , at the REAR of the engine , near the firewall . You won't be able to see it ( at least I can't on my 1995 Ford EXPLORER , which also has the 4.0 , EFI engine )
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
The Dodge Durango was introduced in 1998, so this question cannot be answered. However, in the 2000 Durango.... The camshaft position sensor is located in the distributor on all 3.9L V-6 and 5.2/5.9L V-8 engines Camshaft Position Sensor REMOVAL Distributor removal is not necessary to remove camshaft position sensor Remove air cleaner assembly. Disconnect negative cable from battery. Remove distributor cap from distributor (two screws) Disconnect camshaft position sensor wiring harness from main engine wiring harness. Remove distributor rotor from distributor shaft. Lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor INSTALLATION Install camshaft position sensor to distributor. Align sensor into notch on distributor housing. Connect wiring harness. Install rotor. Install distributor cap. Tighten mounting screws. Install air cleaner assembly. (this info from post on answers.com about cps on 2000 durango)
P0340 is error code for Camshaft Postion Sensor Circuit Malfunction
The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
From what I have read : The camshaft position sensor ( mounted on top of the synchronizer ) on the Ford 4.0 L , EFI V6 engine . Is on top of the engine , near the centerline , at the rear of the engine near the firewall ( apparently you can"t see it unless the upper intake manifold is removed )
try to replace the camshaft position sensor located under the power steering resivoir .. on 4.6 liter lincoln ...