Auto Parts and Repairs
Car Computers and Sensors
Oxygen Sensors
Crankshaft Sensors

Where is the camshaft position sensor on a 1997 Infiniti I30?

313233

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 10:35:08
2011-09-13 10:35:08
location of most new camshaft positionsthe camshaft position sensor is normally located on the distributor just below the houseing for it first try cleaning the inside of dist. cause a lil dirt can cause it to fail but not go outon some vehicles that have no distributor or not one where used to seing you may have to ask a shop to tell you where it would be but few cars are using this setup right now
001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l

The 1997 Chevrolet K 3500 pickup truck camshaft position sensor is located on the back of the cylinder head. The camshaft position sensor should be labeled as such.

The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.

If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.

P0340 Camshaft Position Sensor Circuit

its located in the distributor at the back of the motor.

On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.

have you checked inside the distributor . good luck

P0340 Camshaft Position Sensor Circuit Malfunction

Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt

Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor

Code P1345 is for the crankshaft or camshaft position sensor.

1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.

P0340-CAMSHAFT POSITION SENSOR CIRCUIT, The cam sensor is the pick up plate in the distributor.

Trouble code P0340 means: Camshaft Position Sensor A Circuit (Bank 1 or single sensor)

Trouble code P0341 means: Camshaft Position (CMP) Sensor Performance

Yes. It is in the distributer. Remove the cap and motor and you will see it.

That would be the pick up plate in the distributor under the rotor and cap.

It is mounted on the inside of the distributor. Under the cap. Left top side when looking at it.

I am led to believe that the camshaft position sensor is located at the front right side of the bay...underneath the oil refil cap...to the left of the battery...it has a small grey electrical plug attched with what should be a 10mm bolt. Hope this helps...

On my 94, I6, it was lower right, from the front of the vehicle. There is a wire from the distributor to the sensor. Follow that.

Trouble code P0390 means: Camshaft Position Sensor B Circuit (Bank 2)


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.