There is no coil wire only spark plug wires. The coil pack can be found on the lower passenger side of engine block. It is best seen and accessed from under the vehicle.
The coils are bolted to the ignition control module, there is no coil wire as such.
I would like a diagram showing the firing order on the dis coil of a 1999 Chevy suburban with a v8 with dohc engine
a bad wire or a bad coil to cylinder 5.
On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.
The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.
Unplugging the coil wire and not grounding it, yes that can damage the coil.
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
You need to replace the Distributor cap and rotor. Be sure that the coil wire is not WHITE or RUSTED on the ends were they go in the cap and coil, If they are then replace the COIL and the plug wires too. Just be sure that you use Factory Parts not after market.
The ground wire of the coil. Its the white wire with a black stripe.
On top beside the intake on passenger side of vehical... You can trace coil wire from distributor to find
Bolt The Coil Bracket And Coil To The Block, The - Goes To The Distributor The + Hooks To The Ignition.
negative side of the coil